Steel floor connector installation
Rinforzo Solai

INSTALLATION

Shear connectors for composite structures

    

Composite structures:Timber-concreteSteel-concreteConcrete-concreteDownload area
 

  Applications

   Installation

  Technical data

  DWG Files

Certificates

Software  

   Contact us


The TECNARIA connectors are very simple to install. Once the profiled decking has been positioned over the beam, the two high-resistance nails supplied with the connector are fastened in. The operation is simple, quick and safe. The nails are driven using a powder actuated tool, with a special barrel.

 

 

 

 

 

 

 

 

   

 

©  COPYRIGHT 2003 TECNARIA S.p.A. SUNSTREAMS CONSULTING


  Installation Film
  

  Installation
  Instructions 


Applications
 Installation
 Technicl data
 DWG Files
 Certificates
 Software
 Contact us

Power actuated tool ITW-SPIT® (P 230)
Tool with indirect action and low velocity
Weight: 4,1 kg                 Lengh: 410 mm

 

QUICK, SAFE AND EASY INSTALLATION !

The propulsion power is supplied by the expanding gas of a powder load inserted into the tool's magazine.
Loads are supplied in disk, with various level of power.

Power actuated tool ITW-SPIT® (P 230)

 

 

 

 

TECNARIA undertakes to recommend the best application method on a case-by-case basis.

NAIL SELECTION FOR THE FOLLOWING TYPES OF STEEL*

 Fe 235 Fe 275 Fe 355

FE 235: the connector can be supplied pre-assembled with the nails
FE 275: the connector can be supplied pre-assembled with the nails
FE 355: the connector can be supplied separately,
not pre-assembled
The non-assembled connector for rivet gun fastening applications can be used for all types of
steel. The fastening operation is precisely calibrated and highly reliable.
*According to EN 10027-1

The TECNARIA stud connector can be fastened with the base plate turned either way. In the fastening phase it can adapt to a wide variety of steel deck patterns available on the market (base plate minimum dimensions = 38 mm). To get a correct application the sheet steel must adhere closely to the beam. The base material thickness must be > 8 mm.
Total sheet thickness fastened may not exceed: 2 sheets x 1.0 mm or 1 sheet x 1.5 mm.
 

The connectors can be positioned any way.    
 

        The connectors can be placed side by side, depending only on the dimensions.
 
                


Compatible with all commonly used profiled steel deck.     

Examples of possible plan positions.